Stage 2; Stage 3; Stage 4; Table 6-61: G 896 Service Mode 2 Functions - Miele G 600 Series Technical Information

G 600/G 800

6.8.11.3.2 Stage 2

1. To access Stage 2 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Drain and Salt lights and a lit Rinse light indicate successful accessing of
Service Mode 2.
3. Press the Top solo button once. Flashing Drain and Salt lights and a lit Main wash light
indicate successful accessing of Stage 2 of Service Mode 2.
4. The display will indicate the current operating hours.

6.8.11.3.3 Stage 3

1. To access Stage 3 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Drain and Salt lights and a lit Rinse light indicate successful accessing of
Service Mode 2.
3. Press the Top solo button twice. Flashing Drain and Salt lights and a lit Rinse light
indicate successful accessing of Stage 3 of Service Mode 2.
4. The display will indicate the current electronic version.
5. To save, press the Start/Stop button twice.

6.8.11.3.4 Stage 4

1. To access Stage 4 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Drain and Salt lights and a lit Rinse light indicate successful accessing of
Service Mode 2.
3. Press the Top solo button three times. Flashing Drain and Salt lights and a lit End light
indicate successful accessing of Stage 4 of Service Mode 2.
4. Use the arrow buttons to scroll to the appropriate program function.
5. Use the Top solo button to change the status of the function.
6. To save, press the Start/Stop button twice.
Program
Pots & Pans
Sani Wash
Normal Plus
Normal
China & Crystal
Economy

Table 6-61: G 896 Service Mode 2 Functions

1
Can only be set if "+14 min" is selected in programming mode. See Section 6.8.11.1.2.
Function
Increase temperature
Water softener
Interim rinses
Increase water level
Extended drying
EGS
121
Technical Information
Options Program light status
66 Flashing
72 Lit
On Flashing
Off Lit
1 rinse Flashing
2 rinses Lit
Norm Flashing
Increase Lit
Off Flashing
1
On Lit
With Off
Without On