Setting The Water Hardness; Table 6-20: G 680, G 880 Programming Functions - Miele G 600 Series Technical Information

Technical Information
2. Press and hold the Top solo button while switching the appliance on at the on/off
switch. Release the Top solo button within 2 seconds.
3. The On LED lights up and the Softener LED flashes (if this is not the case,
repeat Steps 1 and 2).
4. Set the program selector switch to the desired function (see Table 6-20).
5. Press Top solo to toggle between the available options.
6. To save the option: Turn the program selector switch to Stop and switch the
appliance off.
Selector switch position
1 o'clock
2 o'clock
3 o'clock

Table 6-20: G 680, G 880 Programming Functions

1
Standard setting
2
Setting not possible; "without softener" is programmed. Modify in service mode 2 (see Section
6.8.4.3), then repeat Steps 1 and 2.
6.8.4.1.1

Setting the Water Hardness

1. Access programming mode.
2. Turn the program selector switch to the 2 o'clock position.
3. Press the Top solo button.
4. Turn the program selector switch to the desired water hardness setting (see Table 6-21).
5. To save the setting, press Top solo, turn the program selector switch to Stop and switch
the appliance off.
Appliance width [cm]
45 (Slimline models)
Function Programmable options
Normal
Drying
Drying Plus
Water hardness -
None
Temperature
reduction
Reduction of 9°F
Program selector
Water hardness switch position
(o'clock)
1 - 5 1
6 - 7 2
8 3
9 4
10 - 11 5
12 - 14 6
15 - 16 7
17 - 21 8
22 - 24 9
25 - 31 10
32 - 35 11
36 - 47 11
48 - 64 11
65 11
94
G 600/G 800
Top solo LED
1
Off
On
Off
1
Off
On
Water hardness
selector in
cabinet
6
6
6
6
6
6
6
6
6
6
3
4
5
6
2