Starting The Test Program; Program Start With Reactivation; Service Mode 2; Fault Codes - Display And Deletion; Table 6-33: G 885 Service Mode 2 Functions - Miele G 600 Series Technical Information

G 600/G 800
Note:
The program steps can be followed with a timing chart. The activation of electrical
components can be performed as the steps are advanced.
If the main switch is switched off or the door is opened, Service Mode 1 will be
cancelled.
6.8.6.2.1

Starting the Test Program; Program Start with Reactivation

If the "Cold pre-wash" program is started in Service Mode 1, the test program is activated.
The test program can be used to check and test all individual components and program
functions. The test program sequence is included with the wiring diagram.
After the test program has been started, the following program will always begin with
reactivation.
6.8.6.3

Service Mode 2

1. Switch off the on/off switch, close the door and turn the program selector switch
to Stop.
2. Press and hold the Top solo and Start buttons together while switching the
appliance on with the on/off switch.
3. Successful accessing of Service Mode 2 is indicated by a dot (.) in the display
and illuminated Drain and Intake LEDs.
4. Turn the program selector switch to the desired setting in accordance with Table
6-33.
5. Press Top solo to toggle between the available options.
6. To save the option: Press Start twice and switch the appliance off.
Selector switch position
1 o'clock
2 o'clock
3 o'clock
4 o'clock
5 o'clock
6 o'clock
7 o'clock

Table 6-33: G 885 Service Mode 2 Functions

1
Standard setting
6.8.6.3.1

Fault Codes - Display and Deletion

1. Access Service Mode 2.
2. Turn the program selector switch to the 1 o'clock position.
3. Check the display against Table 6-34.
4. To delete fault codes, access Programming Mode, press Start twice and switch the
appliance off.
Function
Fault codes
Operating hours
Operating hours
Flow meter
Temperature increase
From program index P1
Softener
From program index P5
Water quantity
103
Technical Information
Programmable Display
options
n/a F00, etc.
First 3 digits of total
n/a
operating hours
Last 3 digits of total
n/a
operating hours
195 to 205 195 to 205
1
150°F 50
160°F 51
1
With 60
Without 61
1
Normal 70
Increased 71