Table of Contents
Advertisement
Before using for the first time
Displaying and setting the water
hardness
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but-
ton.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the Turbo button twice.
The Turbo indicator light will flash rap-
idly twice at intervals.
20
The value set for the water hardness is
shown as a figure after in the display
(see chart).
will start flashing in the display.
This is the factory default setting of
15°d.
Use the programme selector but-
ton to select the value which
equates to your water hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Advertisement
Table of Contents
