Deleting Stored Fault Codes; Program Index; G 680, G 880; Programming Mode - Miele G 600 Series Technical Information

G 600/G 800
6.8.3.3.2

Deleting Stored Fault Codes

Access Programming Mode and turn the dishwasher off.
6.8.3.3.3

Program Index

1. Access Service Mode 2.
2. Turn the program selector switch to the 2 o'clock position. The Top solo light flashes.
3. Press the Top solo button once, then turn the program selector switch slowly clockwise
until the Top solo light lights up. The program selector switch position will determine the
corresponding program index, as shown in Table 6-18 below.
4. Turn the dishwasher off.
Program selector position
1 o'clock
2 o'clock
3 o'clock

Table 6-18: G 811, G 851, G 851 Plus, G 856, G 856 Plus Program Indices

6.8.4

G 680, G 880

Enter Programming Mode
Enter Service Mode 1
Enter Service Mode 2

Table 6-19: G 680, G 880 Programming Flow Chart

Note:
Electronics EPLZ 501 and EPLZ 520 differ from each other in housing, plug
configuration and software. The designation can be checked in Service Mode 2.
EPLZ 520 is marked with the program index "P3" or higher.
6.8.4.1

Programming Mode

1. witch the appliance off at the on/off switch, close the door and turn the program
S
selector switch to Stop.
Program index
P0
P1
P3
Programming Flow Chart
To access:
Water hardness
Drying Plus (EPLZ 501 only)
Temperature reduction (EPLZ 501 only)
To access:
Switching step check
Test program
To access:
Fault indication
Program index
Temperature increase
Softener
Flow meter
Dishwasher width setting
Increased water quantity (EPLZ 520 only)
93
Technical Information
Electronic version
EPLG 542/544
For future modifications
For future modifications