Setting The Water Hardness; Checking The Water Hardness Level; Service Mode 1; 6.8.12.2.1 Test Program - Miele G 600 Series Technical Information

G 600/G 800

6.8.12.1.1 Setting the Water Hardness

1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Press the Sani Wash button. Use the Top solo button to toggle through to the desired
water hardness amount.
4. To save: Press the Start/Stop button twice and turn the dishwasher off.

6.8.12.1.2 Checking the Water Hardness Level

1. Access Programming Mode.
2. Press the Sani Wash button.
3. The number in the display will indicate the programmed water hardness setting.
4. Turn the dishwasher off.
6.8.12.2

Service Mode 1

1. To access Service Mode 1, close the door and turn the dishwasher on. All
program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
Press and hold the "+"and Top solo buttons while turning the dishwasher on.
2.
Successful accessing of Service Mode 1 is indicated by the display showing a
dot (.) and a lit Drain light.
3. Select a program. The program duration will appear in the display.
4. Press the Start/Stop button to start the program. The display will show the
current program step.
5. Pressing the Start/Stop button repeatedly will allow the technician to advance
through the program. If the Start/Stop button is not pressed, the program steps
are carried out automatically, in their normal order.
6. Service Mode 1 will be canceled if the dishwasher is shut off or the door is
opened.
Service Mode 1 can be activated at any time during a wash cycle. When it is
7.
activated during a program cycle, the display will show the current program step.
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
8. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.

6.8.12.2.1 Test Program

The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Press the Rinse & Hold button then press the Start/Stop button. The test program will
start and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.12.3

Service Mode 2

Service Mode 2 is used to change programmed functions and to access fault codes.
Programmed functions include operating hours, increasing the water temperature,
turning on or off the water softener, increasing water intake, adding an interim rinse,
and increasing the circulation fan time.
Technical Information
123