Test Program; Service Mode 2; Stage 1; Table 6-59: G 896 Service Mode 2 Stages - Miele G 600 Series Technical Information

Technical Information
5. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.

6.8.11.2.1 Test Program

The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Using the arrow buttons, select the Rinse & Hold program and press the Start/Stop
button. The test program will start and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.11.3

Service Mode 2

Service Mode 2 is used to determine which upper electronic is in the appliance, to
change programmed functions and to access fault codes. Programmed functions
include increasing the water temperature, turning on or off the water softener, and
adding an interim rinse. Service Mode 2 is divided into 4 stages.
Stage

Stage 1

Stage 2
Stage 3
Stage 4

Table 6-59: G 896 Service Mode 2 Stages

6.8.11.3.1 Stage 1
1. To access Stage 1 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Delay Start and Start/Stop buttons while turning the dishwasher on.
Flashing Drain and Salt lights and a lit Rinse light indicate successful accessing of
Stage 1 of Service Mode 2.
3. The display will indicate the last fault stored (F01, F02, etc.).
4. Use the fault code chart (Table 6-60) to determine the stored fault code.
5. To delete stored fault codes, access the programming mode and press Start/Stop
twice.
Fault code
F00
F01
F02
F03
F04
F05
F06
F07
F08
F09

Table 6-60: G 896 Fault Code Chart

Stage function
Fault codes
Operating hours
Program index
Function programming
Fault
No error
NTC or NTC connections open-circuited
NTC or NTC connections short-circuited
Electronic failure, selector switch position not found
Heating failure - heating circuit opened or defective electrical
component in heating circuit
Water drainage failure, heater level switch
Too few pulses at flow meter / start of water intake
Too few pulses at flow meter / end of water intake
Water intake failure, heater level switch
Heater level switch not switching on at the end of thermal stops
Illuminated light
Rinse
Main wash
Drying
End
120
G 600/G 800