Accessing Fault Codes; Deleting Stored Fault Codes; Operating Hours; G 885 - Miele G 600 Series Technical Information

G 600/G 800
6.8.5.3.1

Accessing Fault Codes

1. Access Service Mode 2.
2. Turn the program selector switch to the 1 o'clock position.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-29) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code
F00
F01
F02
F03
F04
F05
F06
F07
F08
F09
3 dashes (---) in display

Table 6-29: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Fault Code Chart

1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.5.3.2

Deleting Stored Fault Codes

1. Access Programming Mode.
2. Press the Start button twice and turn the dishwasher off.
6.8.5.3.3

Operating Hours

1. Access Service Mode 2.
2. Turn the program selector switch as shown in Table 6-30 below.
Selector switch position
2
3

Table 6-30: G 681, G 881 Novo Stella, G 886 Novo Stella Plus Operating Hours

Example:
2 o'clock position: 007
3 o'clock position: 127
Total operating hours: 7.127 hours
6.8.6

G 885

Fault
No error
NTC or NTC connections open-circuited
NTC or NTC connections short-circuited
Electronic failure, selector switch position not found
Heating failure - heating circuit opened or defective
electrical component in heating circuit
Water drainage failure, heater pressure switch
Too few pulses at flow meter / start of water intake
Too few pulses at flow meter / end of water intake
Water intake failure, heater pressure switch
Heater pressure switch not switching on at the end
of thermal stops
Indicates a F1, F2, F4, or F9 fault is stored in the
memory
Display
First 3 digits of total operating hours
Last 3 digits of total operating hours
101
Technical Information
1