Test Program; Service Mode 2; Stage 1; Table 6-48: G 892, G 832 Service Mode 2 Stages - Miele G 600 Series Technical Information

G 600/G 800
6.8.9.2.1

Test Program

The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Using the arrow buttons, select the Rinse & Hold program and press the Start/Stop
button. The test program will start and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.9.3

Service Mode 2

Service Mode 2 is used to determine which upper electronic is in the appliance, to
change programmed functions and to access fault codes. Programmed functions
include increasing the water temperature, turning on or off the water softener, adding
an interim rinse, and setting the dishwasher width (24"). Service Mode 2 is divided
into 3 stages.
Stage

Stage 1

Stage 2
Stage 3

Table 6-48: G 892, G 832 Service Mode 2 Stages

6.8.9.3.1 Stage 1
1. To access Stage 1 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Start/Stop button while turning the dishwasher on. Release the
Start/Stop button and immediately press it 2 more times. Flashing Intake/Drain and Salt
lights and a lit Rinse light indicate successful accessing of Stage 1 of Service Mode 2.
3. Use the fault code chart (Table 6-49) to determine the stored fault code. Example: A lit
Normal Plus light and a lit Rinse light = NTC or NTC connections short-circuited.
4. To delete stored fault codes, access the Programming Mode and press Start/Stop
twice.
Fault code
F00
F01
F02
F03
F04
F05
F06
F07
Stage function
Fault codes
Program index
Function programming
Program light and
status
Pots & Pans Lit
Sani Wash Lit
Normal Plus Lit
Normal Lit
Economy Lit
Rinse & Hold Lit
Pots & Pans Lit
Sani Wash Lit
Technical Information
Illuminated light
Rinse
Drying
End
Rinse light Fault
status
Lit No error
Lit NTC or NTC connections open-
circuited
Lit NTC or NTC connections short-
circuited
Lit Electronic failure, selector switch
position not found
Lit Heating failure - heating circuit
opened or defective electrical
component in heating circuit
Lit Water drainage failure, heater
level switch
Flashing Too few pulses at flow meter /
start of water intake
Flashing Too few pulses at flow meter /
end of water intake
113