Touchtronic Models; G 890; Programming Mode; Table 6-34: G 885 Fault Codes - Miele G 600 Series Technical Information

Technical Information
Display
F00
F01
F02
F03
F04

Table 6-34: G 885 Fault Codes

Touchtronic Models

6.8.7

G 890

Enter Programming Mode
Enter Service Mode 1
Enter Service Mode 2

Table 6-35: G 890 Programming Flow Chart

6.8.7.1

Programming Mode

1. To access the programming mode, close the door and turn the dishwasher on.
All program lights should light. If not, press the Start/Stop button to cancel the
program.
2. Press and hold the "+"and Start/Stop buttons while turning the dishwasher off,
then on. Successful accessing of the programming mode is indicated by a
blinking Salt light and the display showing P00, P01, etc., depending on the
electronic version.
3. Press the appropriate program button indicated in Table 6-36 to modify the
corresponding function.
4. Use the Top solo button to toggle the functions on or off.
Fault registered
No fault registered
NTC sensor or connections open-circuited
NTC sensor or connections short-circuited
Electronic fault
Heating fault
Programming Flow Chart
To access:
Program index
Water hardness settings
Buzzer
To access:
Manual step mode
Component test program
To access:
Error messages
Operating hours
Flow meter pulses
Increased water temperature selection
Water softener (with/without)
Extended water intake
104
G 600/G 800