Table of Contents
Advertisement
Adjusting Gap Print Head – Platen Assembly
6-2
Adjusting Procedure
This adjustment should be performed with the Top cover attached.
1.
Turn the Power Switch OFF (O).
2.
Detach the Access Cover Assembly.
3.
Turn the Gap Set Lever to Position 1.
4.
Detach the Ink-ribbon Cartridge.
5.
Move the Carrier Assembly to about 80 mm away from the Frame (L) Assembly,
6.
Using Feeler Gauges [1] of 0.35 mm and 0.40 mm, move the Gap Set Bush A [4]
to the front and back so that the gap between the Print Head (24L) [2] and the
Platen Assembly [3] may be adjusted to be between 0.35 and 0.40 mm,
As a standard of proper gap value, a Feeler Gauge of 0.35 mm can be inserted
smoothly but insertion of a Feeler Gauge of 0.40 mm is slightly difficult.
Fig. 6-1: Adjusting the Gap Between the Print Head (24L)
and the Platen Assembly, Step 1
Adjustments and Inspections
[4]
[1]
[3]
[2]
Hide quick links:
Advertisement
Table of Contents
