Detaching and Attaching of Parts Instructions for Dissassembly and Assembly
5-46
5.
Detach the Power Supply Cable [4] from the SUB PCB PL (24L) [5] connector.
6.
Detach all the five Print Unit Cables that are connected to the Main Logic Card
(JPN) connector.
7.
Remove the seven screws [6] and [7] that have been securing the Print Unit.
8.
Move the Print Unit toward the front, then lift it up slowly to detach.
[5]
[4]
[7]
Fig. 5-57: Print Unit, Step 2
Attaching
1.
To attach, reverse the detaching procedure.
Note 1: When connecting the SUB Flex Cable, confirm the connector pattern direc-
tion. Insert all the cables firmly into the connectors.
Note 2: Be sure to confirm the gap between the Print Head (24L) and the Platen
Assembly (refer to Section 6.1).
[6]
[6]
[7]
[7]