Table of Contents
Advertisement
7
Remove the power supply unit and the Type II PCMCIA, and return the jumper
switch to 3-4 short.
8
Replace the Type II PCMCIA, the power supply unit and the server panels.
9
Connect the AC power cable and restart the server.
10
Start the BIOS Setup Utility, set the System Time and Date and select Load Setup
Default from the Exit menu to execute it.
NOTE: The standard settings displayed after the original data is cleared are the
initial data on the motherboard. They may be different from the default (the
recommended settings).
When the original data is cleared, the password(s) for the security menu, and the
SCSI controller data settings are also cleared.
Before clearing any information, remove all expansion cards.
When original data is cleared, data settings on the onboard SCSI controller will also
be cleared. Before clearing information, remove all expansion cards.
Recovery Boot
To execute a recovery boot:
1
Disconnect the AC power cable.
2
Remove the server panels, the power supply unit and the Type II PCMCIA.
3
Set the jumper switch PJ723 on the motherboard of the server to 2-3 short.
PJ723: 2-3 short... Recovery Boot
1-2 short... Normal Boot
4
Install the Type II PCMCIA, the power supply unit, and the server panels.
5
Insert the BIOS Recovery Diskette into the floppy disk drive and turn on the server.
The recovery process takes several minutes.
400
Advertisement
Table of Contents
Troubleshooting
