Throttle Cut - FUTABA 6k Instruction Manual

Throttle cut

THR CUT
Function
This function cuts (stops) the engine or motor
by stick operation. At throttle operation, the rate is
adjusted to the position which completely cuts the
throttle servo or ESC when the throttle is operated.
When THR CUT is active, the throttle position is
held regardless of the throttle stick position.
●The throttle position when the function is reset
can be set so the motor will not unexpectedly
run at high speed when the throttle cut function
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
Cut Position rate
Throttle Position
Switch selection
● Select the setting item
with the Jog key.
Throttle Cut
■ Mode
① Select the "MODE" item and then select the
mode by pressing the + key or – key.
＋
Range：NOR, ESC
Default：NOR
● "NOR"：Engine plane
"ESC"：Electric motor plane
98
② Select
Jog key.
（1 second）
Mode
● Sets the ON/OFF direction of the selected switch.
○ 2P SW：NULL, UP, DOWN
○ 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN, DOWN
－
or
WING TYPE 1AIL
is reset. When the throttle stick is higher than the
set throttle position, the throttle cut function is not
reset even if the switch is set to OFF. Set to a safe
throttle position (slow side).
(NOR/ESC mode the next page referring.)
●Function operation can be selected from among
switches A 〜 D.
●Set the throttle cut function for safety also.
"THR CUT"
from the menu with the
■ Activating the function
② Select the "MIX" item and then select the off
by pressing the + key or – key.
● When you do not use a function, set to the
"INH" side.
(AIRPLANE)
1AIL1FLP 2AIL 2AIL1FLP ELEVON
③ Open the setting screen by
pressing the Jog key.
Activating the function
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch.
● Adjusts the rate to the position
t h a t c o m p l e t e l y c u t s t h e
throttle servo or ESC.
● The value in parentheses is the
current throttle stick position.
＋ －
or