Contents And Technical Specifications; System Compatibilty - FUTABA 6k Instruction Manual

CONTENTS AND TECHNICAL SPECIFICATIONS

Your 6K includes the following components:
• T6K transmitter for airplanes or helicopters
• R3006SB Receiver
• Switch harness
*The set contents depend on the type of set.
Transmitter T6K
(2-stick, 6-channel, T-FHSS Air-2.4G system)
Transmitting frequency: 2.4GHz band
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V Dry battery
Receiver R3006SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS, S.BUS2 system)
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 1.7 x 0.98 x 0.35 in. (43.1 x 25.0 x 8.8 mm)
Weight: 0.3 oz. (8.5g)
Battery F/S Voltage: It sets up with a transmitter
(*1) When using ESC's make sure that the regulated output capacity meets your usage application.
SYSTEM COMPATIBILITY
The 6K is a 2.4GHz T-FHSS Air system . The transmitter can also be switched to S-FHSS . (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
Communications System
T-FHSS Air
（Default）
S-FHSS
（Change is possible）
NOTE：
*The Futaba T-FHSS Air system cannot be used with Futaba S-FHSS/FASST/FASSTest systems. Use
it with a T-FHSS Air system transmitter and receiver. The T6K is a T-FHSS Air system , but can also
be used with an S-FHSS receiver by switching to S-FHSS . However, in this case the telemetry system
cannot be used.
*The T-FHSS Air system and T-FHSS surface system are different. The T6K cannot be used with the
R304SB, R304SB-E or T-FHSS surface system receivers.
(Specifications and ratings are subject to change without notice.)
Usable Receivers
R3006SB, R3008SB
*R304SB, R304SB-E, T-FHSS surface system
receivers do not operate.
R2008SB
R2006GS
R2106GF
15