Parameter; Prmtr - FUTABA 6k Instruction Manual

Parameter function

PRMTR

Function
PARAMETER submenu: sets those parameters
you would likely set once, and then not disturb
again.
LCD contrast（CONTRAST）
Contrast adjustment LCD screen.
● You adjust to legible contrast. set up range -10 〜 +10
Back light（BACK-LIT）
Back light mode of a LCD screen can be chosen.
● ALWAYS / KEY-ON (Shines for a definite period of time after key operation.) / OFF
Light time（LIT-TIME）
Sets the length of time the backlight will stay on.
● Set up range 1 〜 30
Light adjustment（LIT-ADJS）
Light volume adjustment of a back light.
● Set up range 1 〜 30
Battery alarm（BATT ALM）
Select the battery alarm voltage according to the battery to be used.
● 4 dry cell batteries ⇒ 4.2V DR
● HT5F1800B (NiMH battery) ⇒ 5.0V Ni
● FT2F2100BV2 (Lithium ferrite battery) ⇒ 5.8V Fe
Battery alarm vibration（BATT VIB）
Battery alarm is told with vibration.
Buzzer tone （BUZ-TONE）
The tone of buzzer sound when a key is pressed.
● Set up range : OFF,1(low) 〜 100(high)
Home display （HOME-DSP）
Item selection displayed on a home screen
● Futaba logo (Default), TIMER, U-NAME, RX BAT (Case of T-FHSS mode.)
Telemetry mode setting（TLM MODE）
Sets whether or not telemetry is activated. When using 2 receivers with 1 transmitter, select INH.
● Range：ACT / INH
Telemetry display units setting（UNIT）
Sets whether the telemetry display is in meters or yards/pounds.
● Range：METER / YARD （℃ / ℉）
Speech language setting（SPEECH）
Sets the speech language when listening to telemetry information through earphones.
● Range：Japanese ( ニホンゴ J ), English ( Englis )
Speech volume setting（VOLUME）
Sets the volume when listening to telemetry information through earphones.
● Range：LOW / HIGH
Stick position alarm setting（STK ALRM）
Can be set so that an audible alarm sounds once when the throttle stick reaches the set position.
Once you have selected the correct model you
wish to work with, the next step is setting up the
proper parameters for this specific model:
(Common)
63