V-Tail - FUTABA 6k Instruction Manual

V-Tail

V-TAIL
Function
This mixing is used with V tail aircraft that
combine the elevator and rudder functions.
CH2 (CH4)
(Stick mode 2)
Elevator UP
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Activating the function
ELE2 rate
ELE4 rate
RUD2 rate
RUD4 rate
● Select the setting item with
the Jog key.
V-TAIL
■ Activating the function
① Select the "MIX" item and then
select the "ACT" by pressing
the + key or – key.
＋ －
or
● W h e n y o u d o n o t u s e a
function, set to the "INH" side.
NOTE：We recommend that setting be performed while moving the stick and checking the amount of movement. If
the amount of movement is too large, elevator and rudder operation will be compounded and the servo travel range
will be exceeded and a dead band in which the servo will not operate may be created.
WING TYPE
CH4 (CH2)
Elevator DOWN
② Select
"V-TAIL"
from the menu with the
Jog key.
■ Rate adjustment
② Select the value item and then adjust
the mixing rate by pressing the + key or
– key.
Range：-100 ～ +100%
（only ELE4 : -50%）
● When you want to return the set value to the initial value, press
the + key and – key simultaneously.However, polarity does not
return.
1AIL 1AIL1FLP
Rudder Right
③ Open the setting screen by
pressing the Jog key.
（Rate adjustment）
Default：+50%
(GLIDER)
2AIL 2AIL1FLP 2AIL2FLP
Rudder Left
● W h e n I N H i s s e l e c t e d , t h e
function cannot be used. To use
the function, select ACT.
＋ －
or
143