Telemetry
TLMTRY
Function
This screen displays and sets the various information from the receiver. An alarm and vibration can be
generated depending on the information. For example, a drop in the voltage of the receiver battery housed
in the aircraft can be reported by an alarm.
● This function can only be used in the T-FHSS Air mode. The S-FHSS system cannot use telemetry.
● Telemetry sensors sold separately can be mounted in the aircraft to display a variety of information. (Receiver voltage
does not require a sensor.)
● The telemetry function cannot be used if the telemetry mode of the parameters is not ACT.
● When 2 receivers are used with 1 transmitter, the telemetry function cannot be used.
Viewing the receiver voltage.
Viewing the drive battery
voltage.
Using various optional
telemetry sensors.
Setting alarms from the
telemetry information.
-
HOME → → SERVO monitor → → TELEMETRY display
(1 second)
RX-BATT
● Viewing the receiver voltage.
In the initial state, the receiver voltage is displayed at the transmitter.
Display
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
+
Receiver voltage display
Setting is unnecessary. When menu telemetry is
listened to, the voltage appears.
R3008SB, CA-RVIN-700 and wiring work are
necessary.
Optional telemetry sensors are necessary. T6K
setting is unnecessary.
Setting by "Telemetry" in the menu is necessary.
"TLMTRY"
② Select
from the menu with the Jog
key.
-
END key pressed return to HOME.
③ Open the setting screen by
pressing the Jog key.
● How to display receiver voltage
on a home screen.
PARAMETER
HOME-DSP
"RX BATT" is chosen by + key or - key.
(Common)
P.73
P.77
P.81
P.74 ~ 85
73