S.bus/S.bus2 Device Setting - FUTABA 6k Instruction Manual

S.BUS/S.BUS2 DEVICE SETTING

S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T6K. Channel
setting and other data can be entered for the S.BUS/S.BUS2 servos or sensors.
3-way hub
or Y-harnesses
(Telemetry sensor)
46
Back of T6K
Receivers
S.BUS/S.BUS2
device
Battery
(S.BUS/S.BUS2
Servo)
1. Turn on the transmitter power.
2. Call the setup screen.
Servo: → S.BUS
3. Connect the S.BUS device and battery you
want to set with a 3-way hub or Y-harnesses
as shown in the figure.
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.