Telemetry:altitude - FUTABA 6k Instruction Manual

ALTITUDE : Display of SBS-01A (Option), and alarm setup
ALTITUDE is a screen which displays / sets up
the altitude information from an optional altitude
sensor. The altitude of the model which is flying
can be known. If it becomes higher (low) than
preset altitude, you can be told by alarm. To show
warning by vibration can also be chosen. Data
when a power supply is turned on shall be 0 m, and
it displays the altitude which changed from there.
Even if the altitude of an airfield is high, that shall
●Select [ALTITUDE] in the TELEMETRY screen and access
the setup screen shown below by press the Jog key.
● " U P " i n d i c a t e s t h e
alarm will start when
the altitude reaches
above your set value.
● " D N " i n d i c a t e s t h e
alarm will start when
the altitude reaches
below your set value.
● Y o u c a n h e a r t h e
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Move the cursor to the [REFERENCE] of "EXEC"
item.
3. Press the Jog key (1s or more press).
*Atmospheric pressure is changed according to the weather also
at the same airfield. You should preset before a flight.
ALARM set : High side
1. Move the cursor to the UP:(ALARM) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: +200(m)
Adjustment range: -500~+5000(m)
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
84
*An altitude sensor must be installed in the aircraft.
ALTITUDE
MIN/MAX=
(ALARM)
UP▶INH ▶OFF
DN▶INH ▶OFF
REFERENCE▶ EXEC
SPEECH▶ INH
Altitude data through an
earphone or headset,
by Activating the Speech
function.
be 0 m and the altitude difference from an airfield
is displayed. This sensor calculates the altitude
from atmospheric pressure. Atmospheric pressure
will get lower as you go up in altitude, using
this the sensor will estimate the altitude. Please
understand that an exact advanced display cannot
be performed if atmospheric pressure changes in a
weather situation.
● Conversion of a display unit is performed by "TLM UNIT" of
"PARAMETER".
●Altitude
0 m
0 / 0
(VIB) (LIMIT)
▶ +200
▶ -50
SW▶ NULL
●Switch selection
OFF
OFF
ON
2 Position
ALARM set : Low side
1. Move the cursor to the DN:(ALARM) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item .
4. Ajust the rate by press the +-key.
Initial value: -50(m)
Adjustment range: -500~+5000(m)
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
●The maximum and the minimum
when powering ON are shown.
● Maximum and minimum date reset
by pressing the Jog key for 1 second.
"VIB" type
If the following types are selected, the
transmitter will vibrate during the warning.
TYPE 1
TYPE 2
TYPE 3
OFF
ON
3 Position