Pitch Curve - FUTABA 6k Instruction Manual

PIT CRV
Function
The pitch curve function allows setting by a 5
point curve in relation to throttle stick movement
and adjustment of each point over the -100% 〜
+100% range so that the pitch enters the optimum
flight state.
（Normal curve adjustment method）
The normal pitch curve creates a basic pitch curve centered near hovering. This curve is adjusted
together with the throttle pitch curve so that engine speed is constant and up/down control is
easiest.
（Idle up 1/2 curve adjustment method）
The high side pitch curve sets the maximum pitch that does not apply a load to the engine. The low
side pitch curve is created to match the purpose such as loop, roll, and 3D. The idle up 1/2 curves are
used by aerobatics.
（Throttle hold curve adjustment method）
The throttle hold curve is used when performing auto rotation dives. Set the intermediate pitch to
match the stick work at pitch up.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
Activating the function
5point curve
● Select the setting item
with the Jog key.
128

Pitch curve

② Select
（1 second）
Condition
rate
●Normal (NOR), idle up 1 (IDL1), idle up 2 (IDL2), and
hold (HLD) pitch curves can be set.
●The normal (NOR), idle up 1 (IDL1), idle up 2 (IDL2),
and hold (HOLD) switches can be pre-set at the
conditions selection screen.
NOTE：When the hold switch is on, the hold function has
priority even though an idle up switch is in any position.
"PIT CRV"
from the menu with the
Jog key.
（Rate） （Present condition）
(HELICOPTER)
③ Open the setting screen by
pressing the Jog key.
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch. When
normal,"---" (always ON) is
displayed.
● The PIT-CURVE settings are
displayed by a curve.