Throttle Cut - FUTABA T10J Manual

Throttle cut

THR.CUT
Function
This function cuts (stops) the engine or motor
by stick operation. At throttle operation, the rate is
adjusted to the position which completely cuts the
throttle servo or ESC when the throttle is operated.
When Thr.Cut is active, the throttle position is held
regardless of the throttle stick position.
●NOR/ESC operation mode switching. For motor
aircraft, select ESC. For motor aircraft, the throttle
position when the function is reset can be set so
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
（1 second）
Mode
Activating the function
Cut Position rate
Throttle Position
Switch selection
Switch direction
● Select the setting item
with the Jog key.
the motor will not unexpectedly run at high speed
when the throttle cut function is reset. When the
throttle stick is higher than the set throttle position,
the throttle cut function is not reset even if the
switch is set to OFF. Set to a safe throttle position
(slow side).
●Function operation can be selected from among
switches A 〜 H.
●Set the throttle cut function for safety also.
"THR.CUT"
② Select
from the menu with the
Jog key.
THR.CUT
● Sets the ON/OFF direction of the selected switch.
○ 2P SW：NULL, UP, DOWN
○ 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN, DOWN
(ACROBATIC)
③ Open the setting screen by
pressing the Jog key.
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch.
● Adjusts the rate to the position
t h a t c o m p l e t e l y c u t s t h e
throttle servo or ESC.
● The "THR" item can be set
when the operation mode
i s "E S C" . T h e n u m b e r i n
parentheses is the current
throttle stick position.
113