FUTABA 6k Instruction Manual page 109

Air brake
■ Activating the function
① Select the "MIX" item and then select
the "ON" or "OFF" by pressing the +
key or – key.
＋
or
● When you do not use a function, set
to the "INH" side.
■ Delay Rate set
③ Select the "delay" item and adjust the elevator
operation delay by pressing the + key or – key.
● The amount of delay is large at 100%.
Range：0 ～ 100% Default：0%
● When you want to return the set value to the initial value, press the + key
and – key simultaneously.
（In the case of change of a switch）
■ Switch selection
① Select the "SW"
＋
i tem an d t h e n
select the switch
by pressing the
+ key or – key.
Range：SwA ～ SwD
Default：SwC
（In the case of change of a mode）
■ Mode
① S e l e c t t h e
＋
" M O D " i t e m
and select the
operation mode
by pressing the + key or the – key.
Range：OFST, LINR
Default：OFST
（When 3CH control is changed at the time of "LINR"）
■ "LINR" mode 3CH control
① Select the "CH3" item and select control by pressing the +key or –
key.
Range：THR, SwA ～ SwD, VR
■ Rate set
② Select the "rate" item and
－
■ Switch direction
② S e l e c t t h e O N d i r e c t i o n b y
－
or
■ Operation reference point setting ("LINR" mode
－
② Select the operation reference point setting
or
Default：THR
adjust the servo travel by
pressing the + key or – key.
Range：-100 ～ +100%
Default：+50%（ELEV only -10%）
● When you want to return the set value to the initial
value, press the + key and – key simultaneously.
However, polarity does not return.
＋ －
or
pressing the + key or – key at
the ON direction selection item.
Range：
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&DN, UP&CT, CENTR, CT&DN,
DOWN
only)
item newly displayed at the bottom row
of "MOD" and hold the throttle stick at the
air brake start point and set the reference point by
pressing the Jog key for 1 second.
Range：0 ～ 100%
＋ －
or
＋ －
or
109