FUTABA 6k Instruction Manual page 99

Throttle Cut
■ Switch selection
③ Select the "SW" item and then select
the switch by pressing the + key or –
key.
＋
or
Range：SwA ～ SwD
Default：SwA
■ Cut Position rate
⑤ Select the "RATE" item and then select
the cht position by pressing the + key or
– key (motor stop).
＋
or
● It adjusts to the position where an engine
is cut.
Range：-30 ～ 0 ～ +30%
Default：0%
● When you want to return the set value
to the initial value, press the + key and –
key simultaneously.
NOR MODE（Engine）
THR CHT
OFF
ON
Cut switch ON THR stick LOW
(It's possible to do
positional change.）
Release
OFF
ON
Cut switch OFF
THR stick LOW
(It's possible to do
positional change.）
■ Switch direction
④ Select the "POSI" by pressing the + key or – key at
－
－
Engine
stop
THR Active
the ON direction selection item.
＋
or
Range：
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN,
DOWN
■ Function Throttle Position
⑥ Select the "THR" item and then select the position
by THR stick is lowered and Jog key is pressed for 1
second.
● Set to a safe low throttle position.
Range：0 ～ 100%
Default：15%
ESC MODE（Motor）
THR CHT
OFF
ON
Cut switch ON
Release
THR stick
Cut switch OFF
middle-high
(Besides the slow)
OFF
ON
THR stick
Cut switch
LOW
OFF
(It's possible to do
positional change.）
－
Motor Stop
OFF
ON
Motor Stop
Slow→High
Start
99