Install Driftwood Kit 1400Dwk - Valor 1400IN Installation & Owner's Manual

QUALIFIED
INSTALLER

Install Driftwood Kit 1400DWK

Material required
• Driftwood Kit containing:
•
5 logs
•
7 pebbles
•
1 x 1.5 lb bag of 3/4" grey/black shale
• Gloves, if desired
Installation
Logs
Carefully unpack the kit. Install the logs as shown
below.
1. Fill the cavity on the ceramic platform with one layer
of shale pieces.
2. Place the rear log in position inserting its pins into
the holes at the rear of the burner.
3. Place the left log inserting its pin into the hole in the
front of the platform and resting its rear end on fl at
space on the rear log.
NG: Use the rear hole.
LPG: Use the front hole.
54
Installation
4. Notch the left cross log on top of the left log and rest
its curved end on the shale fuel bed. Move pieces
of shale so the log's end rests on the platform itself.
Adjust the position according to fuel used.
NG: The curved end of the log should rest centered in
the shale bed between the front and the rear.
LPG: The curved end of the log should rest forward in
the shale bed, about 1 inch from the front edge of the
burner cavity.