Valor 1400IN Installation & Owner's Manual page 7

2. Push the top of the window frame against the
fi rebox.
Bottom
support
railing
1
3. While you hold it, pull the side levers back into the
window brackets on each side.
3
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
Owner's Information
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
Window
frame overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
2 the frame as indicated.
Hot Glass Warning Plate
6. Reinstall the side doors sliding them sideways to
insert their tabs behind the front face of the trim.
7. Reinstall the barrier screen on the trim.
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
maintenance.
Insert the screen's top
tabs in the slots on
the underside of the
convection baffl e or
heatshield, then insert
the screen's bottom
tabs in the slots of the
removable panel at
the bottom to lock it in
position.
WARNING
!
WARNING
!
Barrier screen's top tabs
coming through slots in
baffl e/heatshield (behind
Trim
the face of the trim)
Convection baffl e or
heatshield
OWNER'S
INFORMATION
7