Table of Contents
Advertisement
QUALIFIED
INSTALLER
Unpack Appliance
Beware of sharp edges! Wear gloves!
1. Remove the cardboard wrapping and the wood
pallet from the appliance and discard.
2. Unpack any loose items from around the appliance.
3. Verify that you have all the components
required for the installation, including:
- approved non combustible cement board;
- liners and fuel bed (in separate cartons);
- surround kit with barrier screen;
- venting components and accessories;
- electrical components if installing optional
blower.
Fit Standoffs
The standoffs are supplied fl at on the fi rebox and fi xed
at one end. Bend them as shown and fi x the loose end
to the top of the fi rebox.
Remove Heat Shield
Remove the heat shield from the top of the appliance
case (3 screws).
Remove heat shield (3 screws)
42
Installation
If using the top outlet, discard the shield. If using a rear
outlet, keep the shield to reinstall after converting the
top to rear outlet—see next subsection.
Convert from Top to Rear Outlet
(if required)
This unit is supplied with a top vent outlet which
can be fi eld-converted to a rear vent outlet.
Please note that the rear outlet requires the
installation of the heat shield on top of the heater
case as indicated.
1. Remove the top outlet collar (6 screws).
Fold Lines
Remove top outlet (6 screws)
2. Swivel the collar and install as a rear outlet (6 screws).
3. Reinstall the heat shield to the top of the appliance
case (3 screws).
Swivel the outlet so
that it is oriented
towards the rear and
reinstall to heater
(6 screws)
Rear outlet with required heat shield
Reinstall heat
shield to top
of appliance
(3 screws)
Advertisement
Table of Contents
