Table of Contents
Advertisement
OWNER'S
INFORMATION
Ensure the screen is secure and seated all the way
down into the bottom slots. There should be a 1"
gap between the top of the barrier screen and the
trim.
8. Verify that the screen is properly hooked and
secure.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Pilot Flame can be seen
under the right rear logs
1400 Driftwood Kit— Correct Flame Picture
1400 Decorative Glass Murano—Correct Flame Picture
1400 Decorative Glass Set—Correct Flame Picture
8
Owner's Information
Pilot Flame can be seen at
the back of the fi re bed
Pilot Flame can be seen at
the back of the fi re bed
Pilot Flame can be seen
under the rear log
1400 Log Set—Correct Flame Picture
Thermocouple
Probe must be in
Flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit.
Low batteries signal: see page 15.
The appliance uses four 1.5 V AA alkaline batteries
for its receiver and two AAA alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life.
Pilot Flame
Advertisement
Table of Contents
