Remote Control Initial Pairing - Valor 1400IN Installation & Owner's Manual

QUALIFIED
INSTALLER

Remote Control Initial Pairing

The receiver and the handset of the remote control sys-
tem must be initially paired before the fi rst use.
1. Insert two 1.5 V AAA alkaline batteries in the
handset.
2. Locate the Reset button on the front side of the
receiver.
3. With a sharp object, press and hold the receiver's
RESET button until you hear one short and one long
beeps. After the second beep, release the reset button.
4. Within the subsequent 20 seconds, press the
button on the remote handset until you hear two
short beeps confi rming the pairing is done. If you
hear one long beep, the pairing sequence has failed
or the wiring is incorrect.
This is a one time pairing only and is not required when
changing the batteries of the handset or receiver. The
remote control system is now ready to use.
62
Installation
AM