Using Handset Wall Holder; Locating Lighting, Operation And Rating Information Card; Servicing Your Fireplace; Operating Your Fireplace - Valor 1400IN Installation & Owner's Manual

To replace the batteries in the receiver:
The receiver is located to the left side of the gas valve
under the removable panel in front of the appliance.
1. Remove the barrier screen and the removable
panel. It is not necessary to remove the side doors.
Note: If it is diffi cult to pull out the panel from its
front edge, use your fi nger and pull from the notches
in the panel at the bottom of the window.
Removable
panel
2. Pull the receiver out.
Receiver
Gas valve
3. Slide the receiver battery compartment's cover off.
4. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the compartment.
5. Replace the cover.
6. Put the receiver back in its location at the left of the
gas valve.
7. Reinstall the removable panel sliding it back under
the side doors until it is fl ush with the sides of the
trim.
8. Reinstall the barrier screen.

Using Handset Wall Holder

Your fi replace equipment includes
a wall holder to store the handset.
If it hasn't be installed, refer to the
instructions further on in this manual
for the installation.
Owner's Information
Locating Lighting, Operation and Rating
Information Card
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION CARD WHILE THE FIREPLACE IS STILL
HOT! Let the fi replace cool fi rst before touching it.
The Lighting, Operation and Rating Information card is
located at the right-hand side of the fi rebox.
To access the information card, remove the barrier
screen and the right-hand side door. Pull it out and
read the important information on both sides.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating card. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.

Operating Your Fireplace

There are two ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional).
The Thermostatic Remote Control can be programmed
to function automatically—see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see the
1265WSK—Wall Switch Kit.
WARNING
!
Thermostatic Wall Switch
Remote Control
OWNER'S
INFORMATION
(optional)
9