Service Requirements; Health & Safety; Electrical Safety; Electrostatic Discharge - Fisher & Paykel DS6021 Service Manual

1.0

SERVICE REQUIREMENTS

1.1 Health & Safety
Note: When servicing the DishDrawer, health and safety issues must be
considered at all times. Specific safety issues are listed below with their
appropriate icon. These are illustrated throughout the service information to
remind service people of the issues.
1.1.1

Electrical Safety

1.1.2

Electrostatic Discharge

1.1.3

Good Working Practices

1.1.4

Isolate Water Supply

1.1.5

Water Leak Check

Ensure the mains power has been disconnected before servicing
the DishDrawer. If the mains supply is required to be on to service
the DishDrawer, make sure it is turned off when removing any
electrical component or connection to avoid electrical shock.
An anti-static strap is to be used as electrical static discharge (ESD)
protection when servicing electronic components.
Ensure the work area is in a tidy and orderly condition at all times so
as not to cause a hazard while service work is being completed.
Always clean and tidy the DishDrawer and work area after service is
completed.
Turn off the water connection tap before servicing.
Check for water leaks as part of the testing after the service has
been completed.
- 5 -