Replacing The Lid Actuator; Replacing The Lid Assembly - Fisher & Paykel DishDrawer DD60 Service Manual

8.23 Replacing the Lid Actuator

1 Remove the tub, refer section 8.13.
2 Remove the lid actuator harness plug by releasing
the clip on the lid actuator.
3 Release the lid actuator from the bottom of the
yoke by pressing with your thumb against one of
the locking tabs.
4 For the right hand actuator, carefully release the
clip at the rear of the lid actuator and slide the lid
actuator towards the rear of the chassis to release
it from the slide rail.
5 For the left hand actuator, the clip is in front of
the lid actuator, and once it is released, the lid
actuator will slide towards the front of the chassis
to release it from the slide rail.
6 The lid actuator can now be removed by dropping
it down through the slot in the middle of the
mounting bracket.
7 When reconnecting the lid actuator to a yoke,
ensure the lid and yoke assemblies are in the
fully raised position. To line up the lid actuator
connecting arm with the yoke, it may need to be
wound up or down manually.
NOTE: It is important that all the clips on the lid actuator case are done up and that none are broken.

8.24 Replacing the Lid Assembly

1 Remove the tub as per section 8.13
2 On the right hand side of the lid, insert a flat blade
screwdriver into the yoke slots between the lid
flange and the yoke, there is one at the front of the
lid and one at the rear.
3 Twist the screwdriver while pulling down on the lid
to disengage the clip. Repeat for each clip on both
yokes.
NOTE: Do not pull down on the lid seal.
4 Pull the lid down 10mm (3/8") on one side. Pull the
opposite side of the lid down until it is clear of the
yoke. The high side of the lid can then be pulled to
the bottom of the yoke slots. The lid is now free to
be removed from the chassis on an angle as shown.
5 To reassemble the lid, angle the lid into the chassis,
ensure the lid is the correct way round, the words
" FRONT" are printed on the top of the lid and
should be at the front of the product.
6 Engage the T-Rib on the high side of the lid into
the bottom of the yoke slots. Swing the opposite
side of the lid past the yoke until it sits into the
bottom of the yoke slots.
NOTE: The T-Ribs make the lid wider, so some force
is required to push past the yoke.
7 Clip the lid into place. Start by pushing one corner
of the lid up until it clicks. Next clip the diagonal
corner up. The lid is now assembled and should
look like the bottom image on the following page.
http://vimeopro.com/fisherpaykeltechnical/training-videos/
video/122004636
8 SERVICING PROCEDURES
clip
wiring
harness
yoke slot
66