Mitsubishi Electric MELSERVO MR-J2S- A Instruction Manual page 77

3. SIGNALS AND WIRING
(b) Speed selection 1 (SP1), speed selection 2 (SP2) and speed command value
Choose any of the speed settings made by the internal speed commands 1 to 3 using speed selection
1 (SP1) and speed selection 2 (SP2) or the speed setting made by the analog speed command (VC).
(Note) External input signals
SP2
0
0
1
1
Note. 0: off
1: on
By making speed selection 3 (SP3) usable by setting of parameter No. 43 to 48, you can choose
the speed command values of analog speed command (VC) and internal speed commands 1 to 7.
(Note) External input signals
SP3
0
0
0
0
1
1
1
1
Note. 0: off
1: on
The speed may be changed during rotation. In this case, the values set in parameters No. 11 and
12 are used for acceleration/deceleration.
When the speed has been specified under any internal speed command, it does not vary due to the
ambient temperature.
(2) Speed reached (SA)
SA turns on when the servo motor speed has nearly reached the speed set to the internal speed
command or analog speed command.
(3) Torque limit
As in Section 3.4.1 (5).
SP1
0 Analog speed command (VC)
1 Internal speed command 1 (parameter No. 8)
0 Internal speed command 2 (parameter No. 9)
1 Internal speed command 3 (parameter No. 10)
SP2 SP1
0 0 Analog speed command (VC)
0 1 Internal speed command 1 (parameter No. 8)
1 0 Internal speed command 2 (parameter No. 9)
1 1 Internal speed command 3 (parameter No. 10)
0 0 Internal speed command 4 (parameter No. 72)
0 1 Internal speed command 5 (parameter No. 73)
1 0 Internal speed command 6 (parameter No. 74)
1 1 Internal speed command 7 (parameter No. 75)
Set speed selection
ON
Start (ST1,ST2)
OFF
Servo motor speed
ON
Speed reached (SA)
OFF
Speed command value
Speed command value
Internal speed
command 2
Internal speed
command 1
3 - 30