Outgoing Groups - Mitel 3000 Installation And Maintenance Manual

From the Programming extension, press the PROGRAM key.
1. Press the Scroll Down key ( ) until "System Programming" is displayed.
2. Select "System Programming".
3. Enter the System Programming Password and select "Lines".
4. Press the Scroll Down key ( ) until "Incoming Calls Only" is displayed.
5. Select "Incoming Calls Only" option.
6. The menu updates to show all B channels and the back up CO lines
7. Select the required lines to be reserved for incoming calls only.
The default setting is that no lines are programmed.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the message
'Restricted' is shown on the display.

Outgoing Groups

Line Selection Method
Two different ways of selecting a line, when the line access codes are used are provided.
Linear Outgoing Line Group: - Requests for an outgoing line are always processed beginning with the highest
numbered line in the group and moving down the list until an available line is found. This is the default setting
for all outgoing groups.
Distributed Outgoing Line Group: The first request will be processed beginning with the highest numbered line
in the group. The next request will begin with the second line, and each subsequent request will begin one line
lower in the group. When the end of the list is reached, requests begin again with the highest numbered line in the
group.
This method applies to switches equipped with CO Lines, T1 (RBS) channels and PRI B-channels. In cases
where CO Lines are provided as well as T1 or PRI, the CO Lines are selected only when all the T1 or PRI
channels are busy.
To Program the Line selection Method
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key ( ) until "Outgoing Groups" is displayed.
6. Select "Outgoing Groups".
7. Select the Group
8. Select either "Linear" or "Distributed".
A "♦" indicates the programmed option
The default is "Linear".
To Program Lines into Groups for Access using the Codes 9 or 760 - 769
CO lines can be grouped together in up to 11 outgoing groups. Each outgoing group is associated with a code.
These codes are 9 or 760 - 769, with group 1 being associated with 9, etc. Dialing a code selects a line from the
associated outgoing group.
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key ( ) until "Outgoing Groups" is displayed.
6. Select "Outgoing Groups".
Select the group you wish to set up.
7.
Select either "Linear" or "Distributed".
8.
Select the lines to be in the group. The lines in the group are indicated by a "♦".
9.
NOTE: Lines can be in one outgoing group only. Selecting a line to be a member of a group automatically
removes it from all other groups.
101
Mitel 3000
Installation & Maintenance Manual