Seat Depth - Permobil F5 Corpus Service Manual

Permobil F5 Corpus

Seat depth

For this task the following tools are necessary:
• 1 Allen key 4 mm.
• 1 Allen key 5 mm.
The seat depth can be adjusted to suit different users.
There are seven fixed levels, each 25 mm / 1" apart.
Adjustment of the seat depth is performed by mounting
the front section of the Seat frame incl. Leg rest and the
rear section of the seat frame incl. Back rest into desired
positions according to the table on 7 and 8. When the
seat depth is adjusted it may be necessary to replace
cushions, seat plates and UniTrack rails for ones of the
appropriate length. The mounting position for the seat on
the seat lift/fixed seat column may also need adjusting.
1. Remove the seat cushion by lifting it straight up. It is
attached by means of Velcro on the rear of the
cushion.
2. Remove the seat plates, which are held in place by
two screws at the back edge and two quick-mount
clamps at the front. See fig. 242. First remove the
screws, then use your hand to carefully push the seat
plate from below to release the quick-mount clamps
at the front.
3. Remove the UniTrack rails which are each held in
place by two screws. See fig. 243.
142
Figure 242. The seat plates are held in place by two
screws at the back edge and two quick-mount clamps at
Figure 243. The UniTrack rails are fixed in place with two
screws each.
Adjustments
the front.