Permobil F5 Corpus Service Manual page 121

Permobil F5 Corpus
Assembly
1. Fit the rear fixing screw (M6x12) and washer for the actuator. See fig. 208. Tighten the screw using a torque
wrench.
Tightening torque 9.8 Nm / 7.2 Ft/lbs.
2. Fit the front fixing screw (M10x60), spacer and washer for the actuator. See fig. 208. Tighten the screw using a tor-
que wrench. Tightening torque: 24 Nm / 17.7 Ft/lbs
3. Fit the lock nut and washer on the front bracket of the actuator. Hold the screw to counteract rotation while tighten-
ing the nut. Tighten the nut using a torque wrench. Tightening torque: 24 Nm / 17.7 Ft/lbs See fig. 208.
4. Secure the cabling for the actuator in its fixing points. Consider the arrangement of the cables carefully and make
sure there is no risk of them getting trapped or otherwise damaged.
Connect the actuator contact to the contact block on the right side of the seat. See fig.207 . Fit the contact by
pushing it straight in at any point.
5. Assemble the UniTrack rail on the right side of the seat. See UniTrack rails, Page 108.
Figure 208. The legrest actuator is held in place by two screws. The actuator cabling is connected to the contact block
above the actuator.
Repairs
121