Troubleshooting R-Net; Troubleshooting Guide - Permobil F5 Corpus Service Manual

Permobil F5 Corpus

TROUBLESHOOTING R-NET

Troubleshooting guide

The following troubleshooting guide describes a number of faults and events which may occur when you use your
wheelchair, together with suggested remedies. Note that this guide cannot describe all the problems and events which
may occur and you should always contact your service contact or Permobil in case of doubt.
EVENT
The wheelchair cannot be started.
The wheelchair cannot be driven.
The wheelchair "switches itself off" after a cer-
tain period of inactivity (20-30 min.).
The wheelchair stops while being driven.
The wheelchair can only be driven at reduced
speed. (Applies with an electric seat lift and
seat angle.)
The wheelchair cannot be charged.
POSSIBLE CAUSE
Batteries discharged.
The cable connection to the control panel has
come loose.
Main fuse switched to OFF position after, for
example, battery replacement.
Main fuse triggered.
Battery charger connected.
Brake release activated.
Wheelchair locked with the security key.
The electronics' energy saving mode has
been activated.
The cable connection to the control panel has
come loose.
Main fuse triggered.
Seat lift or seat angle raised too high. See the
Owner´s manual for more information.
Main fuse switched to OFF position after, for
example, battery replacement.
The charging fuse is triggered
Troubleshooting R-net
REMEDY
Charge the batteries.
Insert the cable in the control panel.
Reset the main fuse. See page 93
See page 93
Stop charging and disconnect the charging
cable from the wheelchair's charging socket.
Reset the brake release.
Unlock the wheelchair. See the Owner's man-
ual for more information.
Switch the wheelchair on again using the start
key on the control panel.
Insert the cable in the control panel.
See page 93
Lower the seat lift or seat angle.
See page 93
Wait for 5 minutes. The fuse will be automati-
cally reset.
159