Permobil F5 Corpus Service Manual page 40

Permobil F5 Corpus
Assembly of front link arms
Assemble in the reverse order.
1. Check that the axle and link arm are not damaged. If necessary, clean to remove dirt and rust. Replaced damaged
parts.
2. Make sure the washer (1) is mounted on the axle. See fig. 48.
3. Fit the link arm (4) on the axle using just your hands. Check that the link arm is fully located on the axle. See fig.50.
4. Fit the screw (6) and washer (5). Tighten the screw with a torque wrench. Tightening torque: 24Nm / 17.7 Ft/lbs
See fig.50.
5. Fit the shock absorber on to the link arm. It is fitted with one screw (3) and washer (2). See fig.50. Tighten the
screw with a torque wrench. Tightening torque: 24Nm / 17.7 Ft/lbs
6. Fit the cover (7) on to the link arm. See fig.50.
7. Fit the drive package covers. See Assembly of the drive package covers including front fender, Page 20.
8. If the wheelchair is equipped with support wheels, refit them. See Support wheel unit, Page 36.
9. Fit the drive wheel. See Drive wheels, Page 29.
40
Figure 50. Fitting/removing the Front link arm
Repairs