Permobil F5 Corpus Service Manual page 104

Permobil F5 Corpus
7. Remove the cover on the back of the back rest. It is
attached with two screws. See fig. 178.
8. Disconnect the Rnet cable from the contact block at
the back of the back rest. See fig. 178. Release the
cable from its cable brackets on the right hand side of
the seat. Make note of how the cable is assembled
with consideration to subsequent assembling. See
Rnet and ICS bus cable mounting, Page 81.
Remove the six screws holding the seat. See fig. 179.
Make note of in what hole pattern the seat is as-
sembled with consideration
assembling.
9. Lift the seat off the AP Elevator.
104
Figure 178. Disconnect the Rnet cable from the contact
to subsequent
Figure 179. The seat is assembled with six screws.
block at back of the back rest.
Repairs