Rip Examples - Edge-Core ES3628EA User Manual

13.4.4 RIP Examples

13.4.4.1 Typical RIP Examples
Interface
vlan1:10.1.1.1/24
Interface SwitchA
vlan2:20.1.1.1/24
In the figure shown above, a network consists of three Layer 3 switches, in which
SwitchA connected with SwitchB and SwitchC, and RIP routing protocol is running in all
of the three switches. SwitchA （interface vlan1：10.1.1.1,interface vlan2：20.1.1.1）
exchanges Layer 3 switch update messages only with SwitchB （interface vlan1： 10.1.1.2） ,
but not with SwitchC（interface vlan 2: 20.1.1.2）.
SwitchA, SwitchB, SwitchC configurations are as follows:
a) Layer 3 SwitchA：
Configure the IP address of interface vlan 1
SwitchA#config
SwitchA(config)# interface vlan 1
SwitchA(Config-if-Vlan1)# ip address 10.1.1.1 255.255.255.0
SwitchA (config-if-Vlan1)#
Configure the IP address of interface vlan 2
SwitchA (config)# vlan 2
SwitchA (Config-Vlan2)# switchport interface Ethernet 0/0/2
Set the port Ethernet0/0/2 access vlan 2 successfully
SwitchA (Config-Vlan2)# exit
SwitchA (Config)# interface vlan 2
SwitchA (Config-if-Vlan2)# ip address 20.1.1.1 255.255.255.0
Initiate RIP protocol and configure the RIP segments
SwitchA(config)#router rip
SwitchA(config-router)#network vlan 1
Interface
vlan1:10.1.1.2/24
Interface
Vlan2:20.1.1.2/24
Fig 13-3 RIP example
377
SwitchB
SwitchC