Pim-Sm Configuration Examples - Edge-Core ES3628EA User Manual

L3 24 10/100 ports + 4ge

Hide thumbs Also See for ES3628EA:

Table of Contents

<access-list-number > is the applying access-list number, it ranges from 1 to 99.

Default: Do not configure the range of pim ssm group address

Command Mode: Global Mode

Usage Guide:

1. Only this command is configured, pim ssm can be available.

2. Before configuring this command, make sure ip pim multicasting succeed. This

command can't work with DVMRP.

3. Access-list can't use the lists created by ip access-list, but the lists created by

access-list.

4.Users can execute this command first and then configure the corresponding acl; or

delete corresponding acl in the bondage. After the bondage, only command no ip pim

ssm can release the bondage.

5 .If ssm is needed, this command should be configured at the related edge route. For

example, the local switch with igmp(must) and multicast source DR or RP(at least one

of the two) configure this command, the middle switch need only enable PIM-SM.

Example: Configure the switch to enable PIM-SSM, the group's range is what is

specified by access-list 23.

Switch (config)#ip pim ssm range 23

16.3.4 PIM-SM Configuration Examples

As shown in the following figure, add the Ethernet interfaces of SwitchA,

SwitchB, switchC and switchD to corresponding vlan, and enable PIM-SM Protocol on

each vlan interface.

Show Quick Links

Table of Contents