Clear Cluster Candidate-Table - Edge-Core ES3628EA User Manual

Example: Set the interval of sending heartbeat packets of the cluster to 10 seconds.
Switch(config)#cluster heartbeat 10

22.3.13 clear cluster candidate-table

Command: clear cluster candidate-table
Function: Clear the list of candidate switches discovered by the commander switch.
Command mode: Admin Mode
Instructions: In the commander switch, this command is used to clear the list of
candidate switches discovered by the commander switch. If this command is executed in
a non-commander switch, an error will be displayed.
Example: Clear the list of candidate switches discovered by the commander switch
Switch#clear cluster candidate-table
22.4 Examples of Cluster Administration
Scenario
The four switches SwitchA-SwitchD, amongst the SwitchA is the command switch and
other switches are member switch. The SwitchB and SwitchD is directly connected with
the command switch, SwitchC connects to the command switch through SwitchB
Fig 22-1 Cluster Administration Configuration
Configuration Procedure
1. Configure the command switch
Configuration of SwitchA
Switch(Config)#cluster run
Switch(Config)#cluster ip-pool 1.2.3.4
Switch(Config)#cluster commander 3628C
Switch(Config)#cluster auto-add enable
2. Configure the member switch
Configuration of SwitchB-SwitchD
799