Edge-Core ES3628EA User Manual page 362

no accept-lifetime
Function: Use this command to specify a key accept on the key chain as a valid time
period. The "no accept-lifetime" command deletes this configuration.
Parameter: <start-time> parameter specifies the start time of the time period, of which
the form should be:
<start-time>={<hh:mm:ss>
<month> <year>}
<hh:mm:ss> specify the concrete valid time of accept-lifetime in hours, minutes
and second
<day> specifies the date of valid, ranging between 1 -31
<month> specifies the month of valid shown with the first three letters of the
month, such as Jan
<year> specifies the year of valid start, ranging between 1993 - 2035
<end-time> specifies the due of the time period, of which the form should be:
<end-time>={<hh:mm:ss>
<month> <year>}
<hh:mm:ss> specify the concrete valid time of accept-lifetime in hours, minutes
and second
<day> specifies the date of valid, ranging between 1 -31
<month> specifies the month of valid shown with the first three letters of the
month, such as Jan
<year> specifies the year of valid start, ranging between 1993 - 2035
<seconds> the valid period of the key in seconds, ranging between
1-2147483646
Infinite means the key will never be out of date.
Default: No default configuration
Command Mode: keychain-key mode
Usage Guide: Refer to the 3.13 RIP authentication Introduction
Example: The example below shows the accept-lifetime configuration of key 1 on the
keychain named mychain
Switch# config terminal
Switch(config)# key chain mychain
Switch(config-keychain)# key 1
Switch(config-keychain-key)# accept-lifetime 03:03:01 Dec 3 2004 04:04:02 Oct 6 2006
13.4.3.2 address-family ipv4
Command: address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf <vrf-name>
<month> <day>
<month> <day>
362
<year>|<hh:mm:ss>
<year>|<hh:mm:ss>
<day>
<day>