Edge-Core ES3628EA User Manual page 590

registration.
Parameter: None
Default: Do not check
Command Mode: Global Mode
Usage Guide: This command configures DR whether or not to check the RP reachability.
Example: Configure DR to check the RP reachability.
Switch (config)#ip pim register-rp-reachability
16.3.3.14 ip pim register-source
Command: ip pim register-source {<A.B.C.D> | <ifname> | <ethernet> | vlan
<vlan-id>}
no ip pim register-source
Function: This command is to configure the source address of register packets sent by
DR to overwrite default source address. This default source address is usually the RPF
neighbor of source host direction.
Parameter: <ifname> is the interface name,
<ethernet> is the ethernet interface,
<vlan-id> is VLAN ID;
<A.B.C.D> is the configured source IP addresses.
Default: Do not check
Command Mode: Global Mode
Usage Guide: The "no ip pim register-source" command restores the default value, no
more parameter is needed. Configured address must be reachable to Register-Stop
messages sent by RP. It's usually a circle address, but it can be other physical addresses.
This address must be announcable through unicast router protocols of DR.
Example: Configure the source address sent by DR.
Switch (config)#ip pim register-source 10.1.1.1
16.3.3.15 ip pim register-suppression
Command: ip pim register-suppression <value>
no ip pim register-suppression
Function: This command is to configure the value of register suppression timer, the unit
is second. The "no ip pim register-suppression" command restores the default value.
Parameter: <value> is the timer's value, it ranges from 1 to 65535s.
Default: 60s
Command Mode: Global Mode
Usage Guide: If this value is configured at DR,it's the value of register suppression timer;
if this value is configured at RP and ipv6 pim rp-register-kat is not used at RP, this
590