Deltabell-We; Installation Steps - Pyronix Enforcer 32WE Setup Manual

DELTABELL-WE

Technical specification
Battery
Strobe duration
Strobe Frequency
Sound pressure level
Dimensions
Reverse polarity protected

Installation Steps:

Step 1
Slide the PCB module upwards. The sprung back-tamper arm can be
retracted to allow removal. This must be done in order to install the
revolving guides - see step 3.
Place the base on a flat surface and ensure it is vertical using the Spirit
level that is already installed. Drill and plug in each of the fixing locations.
The revolving guides will correct any misalignment. If the Deltabell WE
must be mounted on an uneven surface, it is recommended that a tamper
levelling screw is used to ensure correct back-tamper operation. See step 2.
Step 2
Mounting the Deltabell WE on an uneven surface may cause false
triggering, through incorrect operation of the back-tamper.
A POZI number 2 screw driver is recommended for adjusting back tamper
screw.
Step 3
Insert the guides in as shown. Make sure that the guides 'B' is aligned with
the tabs to the right (this is so the PCB module slides in)
Turn each guide until they line up with the drilled holes, while referencing
the spirit level for the correct alignment and fix the base firmly to the wall.
Please note, if the Deltabell WE is installed on an uneven surface, it is
recommended that you do not tighten up the wall screws until after the
module is installed (step 4).
External sounder
CR3 3.0 volt
11000MAh
Lithium battery
10mS
1Hz
101dBA
290 x 285 x 50 mm
Tamper
levelling
screw
28
Tamper
levelling
screw