Shock-We; Technical Specification - Pyronix Enforcer 32WE Setup Manual

Battery

SHOCK-WE

-
LEDs
+
The wireless transmitter with wall tamper and shock sensor is used on the Enforcer Radio Control
Panel along with the current range of detectors, receivers and transmitters.
The function of the shock sensor wireless transmitter is to provide an alarm signal if vibrations picked
up from its mounting surface exceed a predetermined level, which can be easily adjusted.
Front Tamper
Electrical Specification

Technical specification

Rear Tamper
Voltage: >2.5V
Electrical Specification
Current: 12uA
Voltage: >2.5V
Current: 12uA
Battery
Life: Greater than 2 years
Battery
CR2 3.0 Volt
Life: Greater than 2 years
CR2 3.0 Volt
Printed Circuit Board
Link Off and Turn
Battery
potentiometer right for
more sensitive and left
+
for less sensitive
Adjustable PCB settings
Low/High
Sensitivity
Low Range Sensitivity Band:
Low Range Sensitivity Band:
Wireless transmitter with wall tamper and shock sensor
Learn Button
-
LEDs
Battery
-
LEDs
+
Learn Button
Front Tamper
Rear Tamper
Front Tamper
Rear Tamper
Pulse
Sensitivity
Count 4
Band
Pulse
Count 2
-
+
CR2 BATTERY
Link Off and Turn
potentiometer right for
LEARN
more sensitive and left
Link Off and Turn
for less sensitive
potentiometer right for
more sensitive and left
for less sensitive
Sensitivity
High range sensitivity band
Sensitivity
Low range sensitivity band
High range sensitivity band
Disturbance: Rolling 30s period
Low range sensitivity band
Disturbance: Rolling 30s period
Operating Environment
-10 to 50°C
Operating Environment
-10 to 50°C
High Range Sensitivity Band:
Learn Button
LED Enable
Background
Disturbance
High Range Sensitivity Band:
High Range Sensitivity Band:
25
Link On and Turn
potentiometer right for
more sensitive left for
less sensitive
Link On and Turn
potentiometer right for
more sensitive left for
Link On and Turn
less sensitive
potentiometer right for
more sensitive left for
less sensitive