Learning Bells - Pyronix Enforcer 32WE Setup Manual

Learning Bells

It is recommended that all wireless bells are learnt at
the Enforcer before any installation/mounting is done.
This makes learning much quicker.
A maximum of 2 wireless external bells (Deltabell WE)
can be connected to the Enforcer.
Even though the 'learn' may be successful, the
position of the bell box on a property must be tested
for signal strength before it is actually 'fixed' into
place. Please see page 13 when analysing the
wireless range and signal strength.
Before learning each bell check that the battery is
present and is inserted correctly.
Follow the instructions to the right to start learning the
bells.
A bell that is learnt correctly will flash the GREEN LED
briefly and display 'Bell Learnt' on the keypad. Both of
these instances need to occur to indicate a successful
learn.
Green
Blue
,
1 / 2 A 3 D A
+ B E
. C F
4 G 5 J 6 M B
H K N
I L
O
P W
7 8 T 9 C
Q X
R U Y
V
S Z
0
D

BYP
SPACE
Red
Use b and x to scroll to:
RADIO DEVICE
CONTROL?
Control Inputs?
Control Bells?
Learn Devices?
Select Bell
Available
Learning...
10
Press t
Press x
Press t
Press t
[1]
Select Bell
Learnt [2]
Enter Bell. Press t
If 'learnt' is displayed on
a bell, this will need to be
deleted before learning
can begin. See page
12 for deleting bells.
When 'Learning' is
displayed, press and
hold the 'LEARN'
button on the bell until
the LEDs cycle, then
release.
Bell Learnt
Bell Learnt
Already!
If the bell device is already
learnt on the Enforcer
system, 'Bell Learnt
Already!' will be displayed.
Press t