Pyronix Enforcer 32WE Setup Manual page 29

DELTABELL-WE
Step 4
Place the PCB module, ensuring that the arrow is aligned
with the marker (on the left of the module).
Expose the terminals by releasing the latch on the top of the
PCB module.
Step 5
Fit the lid by sliding its hinges into place. The lid can be supported
in the fully open position; to close the lid, apply a little force to
push the lid past the holds.
Close the cover, ensure the tamper is operating correctly and
insert the 25mm long screw supplied and rotate the screw cover
to a close.
Printed circuit board
Learn button
Comfort LED
Enable/Disable
link
Optional
auxillary 12
volt PSU input
Battery
Sounder
Tamper
External sounder
LEARN
AC/DC
+
BAT
-
BATTERY
SOUNDER
TAMPER
The batteries supplied have been
chosen to provide long service life
29
whilst, for safety reasons, having
limited output current.
Tamper
levelling
screw
Red LED
Blue LED
Green LED
The batteries supplied have been
chosen to provide long service life
whilst, for safety reasons, having
limited output current.
Replace only with approved batteries.
Strobe
To prevent possible damage to
components, any static charge on your
body needs to be eliminated before
touching the inside of the unit. This can
be accomplished by touching some
grounded/earthed metallic conductor
Comfort LEDs
such as a radiator/pipework
immediately before replacing batteries.
Battery
Tamper sw
Tampe
levellin
screw
Lea
Com
Ena
link
Opt
aux
volt
Bat
Sou
Tam