Diagnostics - Pyronix Enforcer 32WE Setup Manual

Diagnostics

The diagnostics function shows all wireless (radio)
input and bell signal strengths and battery strengths.
Signal Strength (Inputs and Bells)
One of the most important factors for a reliable
wireless installation is the signal strength between
a wireless device and the panel. If a device is out of
range it will not be able to send events to the Enforcer
panel therefore it is recommended that a signal
strength test is performed before fixing devices into
place. The Enforcer has an advanced signal strength
mechanism that operates by monitoring all inputs/bells
after 5 minutes from the start of the test. It will perform
this test every 16 seconds.
NOTE: When performing a signal strength test it is
recommended that the system is tested in the 'worst
case scenario' for example with all doors and windows
closed.
Once the function is entered, a count down from 300
will begin, when 0 is reached the input results display
will be shown, or press t during the count down
to go to the input display immediately, one of the
following will be displayed:
Result Action
- No device installed
? Waiting for device signal strength
information
0
Missing (reposition and retest)
1 Weak signal (reposition and retest)
2 Good install position
3 Excellent signal
The signal strength can also be read from the wireless
device LEDs.
GREEN LED = Good. RED LED = Bad
When the display is showing the input status, pressing
t will show each individual input and a detailed
signal strength reading will be shown as follows:
Result
Excellent [50 to 100]
Good [30 to 49]
Weak [0-29]
Missing [-]
Action
OK to install
OK to install
Not OK to install
Not OK to install
Use b and x to scroll to:
DIAGNOSTICS?
View PSUs?
View Inputs?
View Radio
Device Status?
Signal Strength?
Inputs?
Please Wait
299
3----------------
-----------------
Input
Excellent
Bells?
?-
13
Press t
Press x
Press x
Press t
Press t
Press t
Press t
Press t
[01]
[100]
Use [ ] Press t
Press t
Press t