Fault Displays - Pyronix Enforcer 32WE Setup Manual

Fault Displays

Radio Mismatch: If an input is assigned as a type (final exit,
intruder, etc) but a detector has not been learnt on this input
number or a detector has been learnt but not assigned an input
type, this fault will be displayed.
Radio Tamper: If a radio input is in tamper, the alarm will
activate and the input in fault will be displayed.
Battery Low: The Enforcer monitors the batteries of each
wireless device and is defined by the following:
Battery Low UXX (U = Keyfobs. XX = User Number)
Battery Low IXX (I = Inputs. XX = Input Number)
Battery Low BXX (B = Bell. XX = Bell Number)
If battery low is displayed it is advisable to replace the
battery within 28 days of this message being shown.
Radio Supervision: The Enforcer monitors the operation of
each wireless device and is defined by the following:
Radio Supervision IXX (I = Input, XX = Input Number)
Radio Supervision BXX (B = Bell, XX = Bell Number)
If this occurs it would be advisable to check the signal strength
of the device in the diagnostics function.
Jamming: This is reported when a jamming signal is recognised
on the radio frequency.
Check that no radio interference is in close proximity to the radio
devices/panel.
Radio Poll Fault: This is displayed when no 'polls' are received
for 20 minutes before the set operation
Test the signal strength / battery on each wireless device.
PLEASE NOTE THAT SETTING MAY NOT BE POSSIBLE IF ANY FAULTS ARE PRESENT ON
THE CONTROL PANEL. PLEASE SEE 'SITE OPTIONS' IN THE MAIN PROGRAMMING MANUAL
TO ALTER THIS SETTING
16
Radio mismatch
Input 01
Alarm Silenced
Input
User
Battery Low U05
Input 02
Superv Fault I02
Unable to set
Jamming 700
Unable to set
Radio poll F700